MIC150-150ING Breakermatic Home Appliances – Electronic Voltage Protector for Microwave ovens, washing machines, dishwasher, dryer and gas stoves

The BREAKERMATIC MICROONDAS has been specially designed to prevent damage to your microwave oven caused by a blackout or a temporary voltage variation, whether too high or too low. It also prevents damage caused by transient voltage spikes. The BREAKERMATIC MICROONDAS will disconnect the outlet in the event of a temporary voltage failure, a blackout, or a flicker, and will keep it disconnected for up to 5 seconds after the fault disappears.

The BREAKERMATIC MICROONDAS absorbs transient spikes produced by the operation of nearby loads or by atmospheric activity, preventing them from reaching your microwave oven without having to unplug it.

It has a type B or NEMA 5-15R outlet, allowing you to connect your microwave oven to the protector without the need for adapters. It also has a type B plug (Nema 5-15P) that allows it to be plugged directly into a wall outlet, without occupying the two positions of a double outlet.

The BREAKERMATIC MICROONDAS handles currents up to 15A and power up to 1875W, a much higher capacity than other similar protectors.

Easy to install and guaranteed 24-hour protection!

Ideal for:

• Microwave ovens 
• Washing Machines 
• Dishwashers
• Dryers 120V or Gas Dryer with 120V motor
• Gas Stoves

Operation

Protection against steady-state voltage variations.

The BREAKERMATIC MICROONDAS disconnects the output if the steady-state voltage is above the high cut-off voltage or below the low cut-off voltage indicated in the specifications. The response time to a fault is delayed to 1 s to prevent false triggering. The voltage must remain outside the range longer than the response time for the disconnection to be activated. While the fault persists, the corresponding high or low voltage indicator will remain lit.

Reconnection delay or wait cycle.

Upon energizing the protector, or upon termination of a voltage fault, the protector will initiate a time delay before connecting the output. The duration of the time delay is indicated in the specifications. The connection delay is designed to allow the power grid to stabilize after a service interruption, and to ensure the proper pressure equalization into the refrigeration system.

Blackout and Brownout Detection.

The protector will disconnect the load if it detects a sudden voltage drop below 50% of the nominal voltage and will initiate a standby cycle. The protector will disconnect the output almost instantaneously to prevent undesired transient voltages reach the protected equipment.

Suppression of fast transient over voltages.

Transient over voltages are very short-duration, high-energy voltage spikes produced by the connection or disconnection of loads or induced by atmospheric discharges near the electrical grid. They propagate through it until they reach the equipment. The BREAKERMATIC MICROONDAS trim transient over voltages between phase and neutral (differential mode) and between current-carrying lines and ground (common mode) without disconnecting the output. It clamps the transient voltages to the indicated voltage protection level.