PIN220-C00EST Aire 220 C – Plug-in Electronic Protector for Convencional Air Conditioners and Cooling Equipment 220Vac 15A NEMA 6-20 (Spanish Edition)

The BREAKERMATIC Aire 220 C is an electronic voltage protector specially designed to prevent damage to your air conditioning equipment caused by a blackout or by high or low voltage. It is ideal for equipment provided with a plug or socket, making it easy to install the protector without disturbing the equipment.

The BREAKERMATIC Aire 220 C will disconnect your equipment in the event of a power failure and will keep it disconnected for the duration of the failure and for the time necessary to equalize the refrigeration system pressures. It will then automatically reconnect your equipment.

Easy to install and guaranteed 24-hour protection! Connect your equipment's plug  to the BREAKERMATIC Aire 220 C outlet, and then directly plug the protector to the wall outlet.

In addition to air conditioning equipment, this protector can be used on any commercial refrigeration equipment equipped with a cord and plug. Its robust construction and high capacity make it ideal for heavy-duty applications.

Ideal For:

• Single-phase mini-split air conditioners up to 15A
• Single-phase refrigeration equipment up to 1 1/2 HP
• Window air conditioners up to 15A
• Freezers
• Display cabinets, coolers, among others.

 Connection and capacity

The BREAKERMATIC AIRE 220 C can operate any equipment with a plug compatible with the protector's NEMA 6-15 outlet. The use of external adapters is not recommended. You must also connect it to a wall outlet compatible with the protector's NEMA 6-15 plug to ensure sufficient current capacity.

Operation

Protection against steady-state voltage variations

The BREAKERMATIC AIRE 220 disconnects the output if the steady-state voltage is above the high cut-off voltage or below the low cut-off voltage indicated in the specifications. In the case of adjustable equipment, the cut-off voltages can be set within the ranges indicated in the specifications. The response time to a fault is typically 1 s. The voltage must remain outside the range longer than the response time for the disconnection to be activated. While the fault persists, the corresponding high or low voltage indicator will remain lit.

Reconnection delay or standby cycle

When the protector is energized, or at the end of a voltage failure, the protector will initiate a time delay before connecting the output. The duration of the time delay is indicated in the specifications. The standby cycle protects sensitive equipment from short operating cycles, allowing, in the case of A/C and refrigeration equipment, system pressures to equalize before reconnecting.

Autostart ®.

This feature reduces the standby cycle to 5 seconds when the protector has been off for a considerable amount of time.

Detection of blackouts and  sags

The protector will disconnect the load if it detects a sudden voltage drop below 50% of the nominal voltage and will initiate a standby cycle.