PTV110-000ING BREAKERMATIC TV’s & Audio – Electronic voltage protector for televisions and audio appliances 120V / 10A (English version)

The BREAKERMATIC TV's & Audio has been specially designed to prevent damage to your television caused by a blackout or a temporary voltage variation, whether too high or too low. It also prevents damage caused by transient voltage spikes. The BREAKERMATIC TV's & Audio protector will disconnect the outlet in the event of a temporary voltage failure, blackout, or flickering, and will keep it disconnected for up to 5 seconds after the fault disappears. Additionally, the BREAKERMATIC TV's & Audio absorbs transient spikes produced by the operation of nearby loads or atmospheric activity, preventing them from reaching your equipment without having to unplug it.

It has two type B or NEMA 5-15R outlets, allowing two devices to be connected simultaneously as long as the sum of the currents or wattages does not exceed 10A or 2200W at 120VAC.

The Type B plug (Nema 5-15P) allows direct connection to a wall outlet, without occupying the two positions of a duplex outlet.

Easy to install and guaranteed 24/7 protection!

Ideal For

Televisions and Monitors: LED, OLED, QLED, LCD, PLASMA, SMART TV
Satellite or Cable Decoders, recorders.

Operation

Protection against steady-state voltage variations.

The BREAKERMATIC TV's & Audio disconnects the output if the steady-state voltage is above the high cut-off voltage or below the low cut-off voltage indicated in the specifications. The response time to a fault is typically 1 s. The voltage must remain outside the range longer than the response time for the disconnection to be activated. While the fault persists, the corresponding high or low voltage indicator will remain illuminated.

Reconnection delay or wait cycle.

Upon energizing the protector, or upon termination of a voltage fault, the protector will initiate a time delay before connecting the output. The duration of the time delay is indicated in the specifications. The short connection delay is designed to allow the power grid to stabilize after a service interruption

Blackout and sag detection.

The protector will disconnect the load if it detects a sudden voltage drop below 50% of the nominal voltage and initiate a standby cycle.

Transient Overvoltage Suppression.

Transient overvoltages are very short-duration, high-energy voltage spikes produced by the connection or disconnection of loads or induced by lightning strikes near the electrical grid, which propagate through it until they reach the equipment. The BREAKERMATIC TV's & Audio interrupts transient overvoltages between phase and neutral (differential mode) and between each current-carrying line and ground (common mode) without disconnecting the output.